raderk wrote:Yes, on ender my arrow disappear and i have direction and delat message.
EnderWiggin wrote:Onionfighter wrote:I see my suggestion was implemented. Thank you. Could you clarify what the prospecting output numbers mean? It appears that 0 means it is pointing directly NW, and that degrees are given with counter-clockwise rotation, is this correct?
yes, you are correct
the direction are the degrees where the vein should be and the delta° is basically the radius of the pie slice.
as onionfighter said:
"direction: 0°" would mean NW
"direction: 180°" would be SE
"direction: 90°" would mean SW
"direction: -90°" would mean NE
"direction: -45°°" would mean N
"direction: 135°°" would mean S
"direction: 45°" would mean W
"direction: -135°°" would mean E
MSpaint example:

hope that helps
