Help setting up the union client on mac

borka · Post by **borka** » Wed Feb 12, 2014 8:37 pm

Problem is you seem to have just the windows versions of jogl and gluegen libaries while you'd need the ones for Mac. Grab the ones you need from your Ender install...

Oh and please reame the Union bla bla bla folder to just Union

cmeks · Post by **cmeks** » Wed Feb 12, 2014 9:30 pm

It's running, thanks

cmeks · Post by **cmeks** » Wed Feb 12, 2014 9:31 pm

basically, i dragged over everything that seemed important from my Ender's client folder, replaced a few things, changed the name to Union (that was crucial, it wouldnt run till after i chagned the name) and then it ran, i'll play with it later tonight after homework is done

borka · Post by **borka** » Wed Feb 12, 2014 9:40 pm

have fun!

cmeks · Post by **cmeks** » Wed Feb 12, 2014 9:40 pm

Next problem, client not being able to pick up the fact that i have bots. I was told i was supposed to have like a "U" icon, but it's not there.

borka · Post by **borka** » Wed Feb 12, 2014 9:51 pm

well i don't know what Union version you have guess you should ask Robben whether he has the "U" and is able to use bots...

cmeks · Post by **cmeks** » Wed Feb 12, 2014 10:32 pm

I have version 7.2c

Help setting up the union client on mac

Re: Help setting up the union client on mac

Re: Help setting up the union client on mac

Re: Help setting up the union client on mac

Re: Help setting up the union client on mac

Re: Help setting up the union client on mac

Re: Help setting up the union client on mac

Re: Help setting up the union client on mac