Mill: can't build milling machine in it!

[pagsiu]

I don't know if it's intended or simply gameplay bug, but I can't place new milling machine after destroying old one in the same windmill. I'm getting error message "The mill needs to be built in a place with available mechanical power." when I try to place the machine. I hope it's fixed asap.

[MagicManICT]

Merged similar bug issues.

[Onep]

Truly, these are the questions we must ask ourselves.

[2d0x]

...when i try to place a milling machine inside the mill i built i get this message: "The mill needs to be built in a place with available mechanical power." ... I had already built one inside the same mill but it came out with ugly colors so i decided to break it and build a better one, but...

Similar problem :\ Error on all floors and in the basement. Another character also can't build.

1. I built the mill.
2. Dug up the basement.
3. I built a milling machine.
4. I tried to put a second mill machine next to it for comparison - an error.
5. I used a mill machine.
6. Removed the first unsuccessful milling machine.
7. Now I have a permanent error.

[PufflePitch]

So, i just removed my old Milling machine to replace it with a better Q one, and it just keeps saying that it needs "mechanical power", even though im inside the mill.



And yeah someone told me that the Q doesnt matter on the machine after i removed it, of course.

Anyone else had this experience? maybe a fix? Really would hate to build a new mill.

[MrPunchers]

I think you need to place it in the same place as the last one because that's where the drive shaft is.

[PufflePitch]

Triend almost everywhere, it just wont. Before i could place it where i wanted. :/

[2d0x]

viewtopic.php?f=47&t=52311

I didn't find a solution and just destroyed the old mill ;\

[PufflePitch]

Rip :/

[Granger]

Can't reproduce this. Won't pursue further unless it happens again.

It just did:

So, i just removed my old Milling machine to replace it with a better Q one, and it just keeps saying that it needs "mechanical power", even though im inside the mill.

And yeah someone told me that the Q doesnt matter on the machine after i removed it, of course.

Anyone else had this experience? maybe a fix? Really would hate to build a new mill.

Topics merged.