Problem whist taming.

RedRamen · Post by **RedRamen** » Fri May 14, 2010 7:02 am

This is my first time taming, everything was going smooth. I landed 20 points on an animal. Then it no longer attacked me, and I can't continue to tame. Any ideas?

Dataslycer · Post by **Dataslycer** » Fri May 14, 2010 8:35 am

Wait for 10 minutes for it to re-aggro then tame it. Repeat until you get 100 points.

RedRamen · Post by **RedRamen** » Fri May 14, 2010 10:09 am

Dataslycer wrote:Wait for 10 minutes for it to re-aggro then tame it. Repeat until you get 100 points.

I was there for over 30 minutes. Never re-aggrod

gork4war · Post by **gork4war** » Fri May 14, 2010 1:14 pm

i had the same problem.

just fence them in, open a corner, the quell them and then just wait. when you attack the animal that you want to tame count ho many animals aggrod you. and when you got your first 20 point there needs to be 1 animal less. then just wait till the one aggros again.

DatOneGuy · Post by **DatOneGuy** » Fri May 14, 2010 2:51 pm

Had this problem until I did 2 at a time, then everything was working smoothly.

Equip 2 ropes and go after 2 at a time for taming.

Turtleshot · Post by **Turtleshot** » Fri May 14, 2010 5:15 pm

Actully, you must aggro another animal of the same herd and the one you were taming will automatically aggro you, letting you tame it again.

RedRamen · Post by **RedRamen** » Fri May 14, 2010 10:25 pm

I also have another problem. I've landed a few quells, but sometimes, the intensity goes up RIGHT before quell lands.

What's the way around this?

Problem whist taming.

Problem whist taming.

Re: Problem whist taming.

Re: Problem whist taming.

Re: Problem whist taming.

Re: Problem whist taming.

Re: Problem whist taming.

Re: Problem whist taming.