Tanning Tub Problem

[mindwarp]

My tanning tubs are stuck at 92%. They have full water and bark. What is wrong?

[Zekera]

If they are inside something they will stay at 92%.. If they are inside a house or basement and you leave and come back then you will restart at 92% ..Basically, put them outside and leave them outside till they turn into leather.

[DigDog]

It's not the problem that they're inside, it's the problem that rarely people are inside. If your tanning tub is in an area where no people are for a while it resets back to 92%. Just put them into a place where people often walk around. So putting them outside is a really good idea.

[xweetok59]

Or not to expect that it will go to 100% in two minutes. It will take around one hour.

[lokerrt]

Or not to expect that it will go to 100% in two minutes. It will take around one hour.

38.4 minutes

[DigDog]

I always wondered but never got around to actually test it, is it the same for bear hides? I noticed bear hides take a longer (double?) time to dry, do they take longer to tan, too?

[lokerrt]

I always wondered but never got around to actually test it, is it the same for bear hides? I noticed bear hides take a longer (double?) time to dry, do they take longer to tan, too?

I didn't actually test it tbh. It just says in the wiki that it takes 8 hours to make leather. 38.4 min is 8% of that.

[DigDog]

I always wondered but never got around to actually test it, is it the same for bear hides? I noticed bear hides take a longer (double?) time to dry, do they take longer to tan, too?

I didn't actually test it tbh. It just says in the wiki that it takes 8 hours to make leather. 38.4 min is 8% of that.

No, those numbers are correct for normal hides. I was just wondering if it's more for bear hides.