Prospecting on ender

[raderk]

How it exatcly works?

[Mashadar]

The same way it does on the other clients.

[novaalpha]

The same way it does on the other clients.

You've never prospected on ender client, right? It's quite a bit different.

[Mashadar]

You've never prospected on ender client, right? It's quite a bit different.

I am using Ender's client, so I have. Are you referring to the additional direction message?

[novaalpha]

You've never prospected on ender client, right? It's quite a bit different.

I am using Ender's client, so I have. Are you referring to the additional direction message?

Well that's probably what OP is asking.

[raderk]

Yes, on ender my arrow disappear and i have direction and delat message.

[kaoz]

Yes, on ender my arrow disappear and i have direction and delat message.

I see my suggestion was implemented. Thank you. Could you clarify what the prospecting output numbers mean? It appears that 0 means it is pointing directly NW, and that degrees are given with counter-clockwise rotation, is this correct?

yes, you are correct

the direction are the degrees where the vein should be and the delta° is basically the radius of the pie slice.
as onionfighter said:

"direction: 0°" would mean NW
"direction: 180°" would be SE
"direction: 90°" would mean SW
"direction: -90°" would mean NE
"direction: -45°°" would mean N
"direction: 135°°" would mean S
"direction: 45°" would mean W
"direction: -135°°" would mean E

MSpaint example:




hope that helps

[Jackwolf]

I think you have it backwards... on your thing, the Direction 45 is pointing to the east.

[kaoz]

I think you have it backwards... on your thing, the Direction 45 is pointing to the east.

oops forgot to say the "windows" i put there are in the positions of the tiles i tested,(forgot to move them to clarify more) but the directions i gave are right.

[Jackwolf]

So 0 degree is when you were standing north west of it, and 180 degree was south east of it?