-
whargharbl
- Posts: 2
- Joined: Fri Dec 30, 2011 9:48 pm
Ender's Client Blackscreen on Login (Sorry)
Last edited by whargharbl on Mon Jan 02, 2012 3:11 am, edited 1 time in total.
-
EnderWiggin
- Posts: 1156
- Joined: Sat Mar 20, 2010 8:23 pm
Re: Ender's Client Blackscreen on Login (Sorry)
well, I think Wizard's tower is more appropriate. This forum is for default client or client independend bugs.
Could you put pause as last line of your bat file and post any error messages that appear there? And try to wait for a few minutes - sometimes it takes a long time for client to load.
Could you put pause as last line of your bat file and post any error messages that appear there? And try to wait for a few minutes - sometimes it takes a long time for client to load.
-
whargharbl
- Posts: 2
- Joined: Fri Dec 30, 2011 9:48 pm
Re: Ender's Client Blackscreen on Login (Sorry)
Ok, I added pause but got the same problem after leaving it for 10 or more minutes. There are no error messages either, which really isnt helpful I know, sorry. Thanks for the reply though.EnderWiggin wrote:well, I think Wizard's tower is more appropriate. This forum is for default client or client independend bugs.
Could you put pause as last line of your bat file and post any error messages that appear there? And try to wait for a few minutes - sometimes it takes a long time for client to load.
