Problems rotating the camera

[algam]

I use bad camera.
Sometimes , especially after start, for a few seconds the click with middle mouse button does not rotate the camera.
Today I could not do this neither in Ender nor vanilla clients for a longer time.
After a few restarts it started working on Ender (did not check in vanilla since I do not use it in general) at first around 70% of tries. After 2-3 minutes works okay.

Does this happens to anybody else or it might be just a sign to change my mouse?

Is there any other way to rotate camera than middle button?

[meus]

You can try to rotate the camera with arrow keys on the keyboard (you're using "bad" camera).
But it's most probably the mouse middle button's fault, also it might be low batteries if it's wireless.

[algam]

Thanks meus. It is even more comfortable using the keys.

[Pommfritz]

I had a similiar issue but I think it was because my middle mouse button is just kinda broken xd I did rebind the middle mouse button key to a key on the side of my mouse in my driver, works fine.